Set-DhcpServerv4Scope

Sets the properties of an existing IPv4 scope on the DHCP server service. Windows Server PowerShell reference

From the Windows Server PowerShell reference 21 parameters Its page in the reference

Parameters

21 in the Windows Server PowerShell reference

Show its 21 parameters

-ActivatePoliciesSpecifies the enabled state for the policy enforcement on the scope.

-AsJobRuns the cmdlet as a background job.

-CimSession, -SessionRuns the cmdlet in a remote session or on a remote computer.

-ComputerName, -CnSpecifies the DNS name, or IPv4 or IPv6 address, of the target computer that runs the DHCP server service.

-Confirm, -cfPrompts you for confirmation before running the cmdlet.

-DelaySpecifies the time, in milliseconds, by which the DHCP server service should delay sending a response to the clients.

-DescriptionSpecifies the description to set for the scope.

-EndRangeSpecifies the ending address of the IPv4 range to set for the scope.

-LeaseDurationSpecifies the duration of the IPv4 address lease to give for the clients of the scope.

-MaxBootpClientsSpecifies the maximum number of Bootp clients permitted to get an IP address lease from the scope.

-NameSpecifies the name for the scope.

-NapEnableSpecifies the enabled state for network access protection (NAP) for the scope.

-NapProfileSpecifies the name of the NAP profile for clients in the scope.

-PassThruReturns an object representing the item with which you are working.

-ScopeIdSpecifies the scope identifier (ID), in IPv4 address format, for which the properties are set.

-StartRangeSpecifies the starting address of the IPv4 range to set for the scope.

-StateSpecifies the state of the scope.

-SuperscopeNameSpecifies the name of the superscope to which this scope is added.

-ThrottleLimitSpecifies the maximum number of concurrent operations that can be established to run the cmdlet.

-TypeSpecifies the type of the scope.

-WhatIf, -wiShows what would happen if the cmdlet runs.