CmdID

CmdID / PowerShell / Cmdlets / Set

Set-OutboundConnector

Use the Set-OutboundConnector cmdlet to modify an existing Outbound connector in your cloud-based organization. Exchange PowerShell reference

From the Exchange PowerShell reference 24 parameters Its page in the reference

Opens CmdID with your command, read as PowerShell. It is read in your browser and sent nowhere.

Parameters

24 in the Exchange PowerShell reference
Show its 24 parameters
-IdentityThe Identity parameter specifies the connector you want to modify.
-AllAcceptedDomainsThe AllAcceptedDomains parameter specifies whether the Outbound connector is used in hybrid organizations where message recipients are in accepted domains of the cloud-based organization.
-CloudServicesMailEnabledThe CloudServicesMailEnabled parameter specifies whether the connector is used for hybrid mail flow between an on-premises Exchange environment and Microsoft 365.
-CommentThe Comment parameter specifies an optional comment.
-Confirm, -cfThe Confirm switch specifies whether to show or hide the confirmation prompt.
-ConnectorSourceThe ConnectorSource parameter specifies how the connector is created.
-ConnectorTypeThe ConnectorType parameter specifies a category for the domains that are serviced by the connector.
-EnabledThe Enabled parameter specifies whether to enable or disable the Outbound connector.
-IsTransportRuleScopedThe IsTransportRuleScoped parameter specifies whether the Outbound connector is associated with a transport rule (also known as a mail flow rule).
-IsValidatedThe IsValidated parameter specifies whether the Outbound connector is validated.
-LastValidationTimestampThe LastValidationTimestamp parameter specifies the date/time that the Outbound connector was validated.
-MtaStsModeThe MtaStsMode parameter provides admin control over outbound MTA Strict Transport Security (MTA-STS) validation for email sent over the outbound connector.
-NameThe Name parameter specifies the unique name for the connector.
-RecipientDomainsThe RecipientDomains parameter specifies the domain that the Outbound connector routes mail to.
-RouteAllMessagesViaOnPremisesThe RouteAllMessagesViaOnPremises parameter specifies that all messages serviced by this connector are first routed through the on-premises email system.
-SenderRewritingEnabledThe SenderRewritingEnabled parameter specifies that all messages that normally qualify for SRS rewriting are rewritten for routing through the on-premises email system.
-SmartHostsThe SmartHosts parameter specifies the smart host that the Outbound connector uses to route mail.
-SmtpDaneModeThe SmtpDaneMode parameter provides admin control over outbound SMTP DNS-based Authentication of Named Entities (DANE) validation for email sent over the outbound connector.
-TestModeThe TestMode parameter specifies whether you want to enabled or disable test mode for the Outbound connector.
-TlsDomainThe TlsDomain parameter specifies the domain name that the Outbound connector uses to verify the FQDN of the target certificate when establishing a TLS secured connection.
-TlsSettingsThe TlsSettings parameter specifies the TLS authentication level that's used for outbound TLS connections established by this Outbound connector.
-UseMXRecordThe UseMXRecord parameter enables or disables DNS routing for the connector.
-ValidationRecipientsThe ValidationRecipients parameter specifies the email addresses of the validation recipients for the Outbound connector.
-WhatIf, -wiThe WhatIf switch shows what the command does without making any changes.