CmdID

CmdID / PowerShell / Cmdlets / Set

Set-RoutingGroupConnector

Use the Set-RoutingGroupConnector cmdlet to modify the properties of an existing routing group connector between a Microsoft Exchange Server 2010 routing group and an Exchange Server 2003 routing group. Exchange PowerShell reference

From the Exchange PowerShell reference 10 parameters Its page in the reference

Opens CmdID with your command, read as PowerShell. It is read in your browser and sent nowhere.

Parameters

10 in the Exchange PowerShell reference
-IdentityThe Identity parameter specifies the name or GUID of the routing group connector.
-Confirm, -cfThe Confirm switch specifies whether to show or hide the confirmation prompt.
-CostThe Cost parameter specifies a cost to the connector.
-DomainControllerThe DomainController parameter specifies the domain controller that's used by this cmdlet to read data from or write data to Active Directory.
-MaxMessageSizeThe MaxMessageSize parameter specifies the maximum size of a message that can pass through a routing group connector.
-NameThe Name parameter specifies the name of the routing group connector.
-PublicFolderReferralsEnabledThe PublicFolderReferralsEnabled parameter specifies whether users can use this routing group connector to access a public folder replica located in the routing group of the target servers when an in…
-SourceTransportServersThe SourceTransportServers parameter specifies the host name or FQDN of the transport servers that are used to send messages to the target transport servers.
-TargetTransportServersThe TargetTransportServers parameter specifies the host name or FQDN of the transport servers that receive messages from the source transport servers.
-WhatIf, -wiThe WhatIf switch shows what the command does without making any changes.