CmdID

CmdID / PowerShell / Cmdlets / Set

Set-ServerComponentState

Use the Set-ServerComponentState cmdlet to configure and update Microsoft Exchange components and endpoints on servers you specify. Exchange PowerShell reference

From the Exchange PowerShell reference 10 parameters Its page in the reference

Opens CmdID with your command, read as PowerShell. It is read in your browser and sent nowhere.

Parameters

10 in the Exchange PowerShell reference
-IdentityThe Identity parameter specifies the Exchange server where you want to run this command.
-ComponentThe Component parameter specifies the component or endpoint for which you want to set the state.
-RequesterThe Requester parameter specifies the system requesting this state change.
-StateThe State parameter specifies the state that you want for the component.
-Confirm, -cfThe Confirm switch specifies whether to show or hide the confirmation prompt.
-DomainControllerThe DomainController parameter specifies the domain controller that's used by this cmdlet to read data from or write data to Active Directory.
-LocalOnlyThe LocalOnly switch specifies that the changes are written to the registry of the Exchange server only and not to Active Directory.
-RemoteOnlyThe RemoteOnly switch specifies that the changes are written to Active Directory only and not to the registry of the Exchange server.
-TimeoutInSecondsThis parameter is reserved for internal Microsoft use.
-WhatIf, -wiThe WhatIf switch shows what the command does without making any changes.