CmdID

CmdID / PowerShell / Cmdlets / Set

Set-UMCallRouterSettings

Use the Set-UMCallRouterSettings cmdlet to modify the configuration of the Microsoft Exchange Unified Messaging Call Router service. Exchange PowerShell reference

From the Exchange PowerShell reference 11 parameters Its page in the reference

Opens CmdID with your command, read as PowerShell. It is read in your browser and sent nowhere.

Parameters

11 in the Exchange PowerShell reference
-ServerThe Server parameter specifies the Exchange server where you want to run this command.
-Confirm, -cfThe Confirm switch specifies whether to show or hide the confirmation prompt.
-DialPlansThe DialPlans parameter specifies the dial plan used by the Microsoft Exchange Unified Messaging Call Router service.
-DomainControllerThe DomainController parameter specifies the domain controller that's used by this cmdlet to read data from or write data to Active Directory.
-IPAddressFamilyThe IPAddressFamily parameter specifies the Internet Protocol (IP) version to use.
-IPAddressFamilyConfigurableThe IPAddressFamilyConfigurable parameter specifies whether you're able to set the IPAddressFamily parameter to IPv6Only or Any.
-MaxCallsAllowedThis parameter is deprecated and no longer used.
-SipTcpListeningPortThe SipTcpListeningPort parameter specifies the TCP port that's used by the Microsoft Exchange Unified Messaging Call Router service to receive incoming calls.
-SipTlsListeningPortThe SipTlsListeningPort parameter specifies the Transport Layer Security (TLS) port that's used by the Microsoft Exchange Unified Messaging Call Router service to receive incoming calls.
-UMStartupModeThe UMStartupMode parameter specifies whether the Microsoft Exchange Unified Messaging Call Router service starts up in TCP, TLS, or Dual mode.
-WhatIf, -wiThe WhatIf switch shows what the command does without making any changes.