CmdID

CmdID / PowerShell / Cmdlets / Set

Set-UMIPGateway

Use the Set-UMIPGateway cmdlet to modify the configuration settings for a single Unified Messaging (UM) IP gateway or to return a list of configuration settings that can be modified on a specified UM IP gateway. Exchange PowerShell reference

From the Exchange PowerShell reference 14 parameters Its page in the reference

Opens CmdID with your command, read as PowerShell. It is read in your browser and sent nowhere.

Parameters

14 in the Exchange PowerShell reference
-IdentityThe Identity parameter specifies the identifier for the UM IP gateway being modified.
-AddressThe Address parameter specifies the IP address or the fully qualified domain name (FQDN) configured on the UM IP gateway or SIP-enabled IP PBX.
-Confirm, -cfThe Confirm switch specifies whether to show or hide the confirmation prompt.
-DelayedSourcePartyInfoEnabledThe DelayedSourcePartyInfoEnabled parameter specifies whether Unified Messaging should delay the process of accepting an inbound call from the Voice over IP (VoIP) gateway if the corresponding SIP IN…
-DomainControllerThe DomainController parameter specifies the domain controller that's used by this cmdlet to read data from or write data to Active Directory.
-ForceUpgradeThe ForceUpgrade switch suppresses the confirmation message that appears if the object was created in a previous version of Exchange.
-IPAddressFamilyThe IPAddressFamily parameter specifies the Internet Protocol (IP) version to use.
-MessageWaitingIndicatorAllowedThe MessageWaitingIndicatorAllowed parameter specifies whether to enable the UM IP gateway to allow SIP NOTIFY messages to be sent to users associated with a UM dial plan and the UM IP gateway.
-NameThe Name parameter specifies the display name for the UM IP gateway.
-OutcallsAllowedThe OutcallsAllowed parameter specifies whether to allow this UM IP gateway to be used for outgoing calls.
-PortThe Port parameter specifies the IP port on which the IP gateway or IP PBX is listening.
-SimulatorThe Simulator parameter specifies the simulator used for the UM IP gateway being viewed.
-StatusThe Status parameter specifies whether to enable or disable the UM IP gateway.
-WhatIf, -wiThe WhatIf switch shows what the command does without making any changes.