CmdID

CmdID / PowerShell / Cmdlets / Test

Test-PopConnectivity

Use the Test-PopConnectivity cmdlet to verify that the Microsoft Exchange POP3 service is working as expected. Exchange PowerShell reference

From the Exchange PowerShell reference 14 parameters Its page in the reference

Opens CmdID with your command, read as PowerShell. It is read in your browser and sent nowhere.

Parameters

14 in the Exchange PowerShell reference
-ClientAccessServerThe ClientAccessServer parameter specifies the Exchange server to test.
-Confirm, -cfThe Confirm switch specifies whether to show or hide the confirmation prompt.
-ConnectionTypeThe ConnectionType parameter specifies the type of connection that's used to connect to the POP3 service.
-DomainControllerThe DomainController parameter specifies the domain controller that's used by this cmdlet to read data from or write data to Active Directory.
-LightModeThe LightMode switch tells the command to perform only a test logon to the server by using the POP3 protocol.
-MailboxCredentialThe MailboxCredential parameter specifies the mailbox credential to use for a single mailbox test.
-MailboxServerThe MailboxServer parameter specifies the Exchange Mailbox server that you want to test.
-MonitoringContextThe MonitoringContext switch includes the associated monitoring events and performance counters in the results.
-PerConnectionTimeoutThe PerConnectionTimeout parameter specifies the amount of time, in seconds, to wait per connection for the test operation to finish.
-PortClientAccessServerThe PortClientAccessServer parameter specifies the port to use to connect to the Client Access server.
-ResetTestAccountCredentialsThe ResetTestAccountCredentials switch resets the password for the test account that's used to run this command.
-TimeoutThe Timeout parameter specifies the amount of time, in seconds, to wait for the test operation to finish.
-TrustAnySSLCertificateThe TrustAnySSLCertificate switch allows Exchange to accept certificates from untrusted certification authorities (CAs).
-WhatIf, -wiThe WhatIf switch shows what the command does without making any changes.