CmdID

CmdID / PowerShell / Cmdlets / Test

Test-UMConnectivity

Use the Test-UMConnectivity cmdlet to test the operation of Unified Messaging (UM) servers. Exchange PowerShell reference

From the Exchange PowerShell reference 24 parameters Its page in the reference

Opens CmdID with your command, read as PowerShell. It is read in your browser and sent nowhere.

Parameters

24 in the Exchange PowerShell reference
Show its 24 parameters
-PhoneThe Phone parameter specifies the telephone number or Session Initiation Protocol (SIP) Uniform Resource Identifier (URI) used when the test call is redirected.
-PINThe PIN parameter specifies the PIN associated with the UM-enabled mailbox.
-ResetPINThe ResetPIN parameter specifies whether to generate or regenerate a new PIN for all the test mailboxes in the current site.
-TUILogonThe TUILogon parameter specifies whether the cmdlet tries to log on to one or more UM-enabled mailboxes.
-TUILogonAllThe TUILogonAll parameter specifies whether to try to connect to all test mailboxes in the current Active Directory site.
-UMDialPlanThe UMDialPlan parameter specifies the UM dial plan to be tested.
-UMIPGatewayThe UMIPGateway parameter specifies the name of the UM IP gateway or IP PBX to use for the outgoing test call.
-CallRouterThe CallRouter switch specifies whether to test the Microsoft Exchange Unified Messaging Call Router service (front-end).
-CertificateThumbprintThe CertificateThumbprint parameter specifies the certificate thumbprint used for SIP Secured and Secured mode.
-Confirm, -cfThe Confirm switch specifies whether to show or hide the confirmation prompt.
-DiagDtmfDurationInMilisecsThe DiagDtmfDurationInMilisecs parameter specifies the duration of each digit sent.
-DiagDtmfSequenceThe DiagDtmfSequence parameter specifies the sequence of digits sent.
-DiagInitialSilenceInMilisecsThe DiagInitialSilenceInMilisecs parameter specifies the time period in milliseconds that the cmdlet pauses before the digit sequence is sent.
-DiagInterDtmfDiffGapInMilisecsThe DiagInterDtmfDiffGapInMilisecs parameter specifies whether to customize the time between the digits in the diagnostic sequence.
-DiagInterDtmfGapInMilisecsThe DiagInterDtmfGapInMilisecs parameter specifies the time in milliseconds between each digit sent in the digit sequence.
-DomainControllerThe DomainController parameter specifies the domain controller that's used by this cmdlet to read data from or write data to Active Directory.
-FromThe From parameter specifies the SIP URI or SIP address that the call originated from.
-ListenPortThe ListenPort parameter specifies the IP port number on which to listen.
-MediaSecuredThe MediaSecured parameter specifies whether to use Secure RTP or RTP (unsecured) mode.
-MonitoringContextThe MonitoringContext parameter specifies whether to include the associated monitoring events and performance counters in the results.
-RemotePortThe RemotePort parameter specifies the port used for the call.
-SecuredThe Secured parameter specifies whether the test is run in SIP Secured mode.
-TimeoutThe Timeout parameter specifies the length of time in seconds to wait for the test operation to finish.
-WhatIf, -wiThe WhatIf switch shows what the command does without making any changes.